SH Series Stainless Ball Bearings with Aligning Ring

Addition of aligning function to standard stainless ball bearings can allow them to require less maintenance by allowing the flexure of roller or shaft, together with corrosion resistance of stainless steel.
PDF Catalog download ↓

Features

  1. Made of AISI440C stainless steel, and suitable in corrosive environment, in clean room and for food machinery.
  2. Reducing the excess strain on bearing, by aligning the flexure of the conveyor roller’s shaft or the error of shaft center.
  3. tomeneji-tok2-e2

  4. Available with seals and shields, and suitable in dusty or watery environment.
  5. tomeneji-tok3-e2

  6. Interchangeable to 6200, 6300, 1200 and 1300 series bearings.  The dimensions are the same, except the width of the bearing inside.
  7. tomeneji-tok4-e2

  8. The SH series bearings have more advantages than the standard self-aligning bearings made of SAE52100 steel.

tomeneji-tok5-e2

Product Specifications

●SSA type with aligning function

Standard Specifications
Aligning ring AISI440C
Inner and Outer Rings AISI440C
Balls*1 AISI440C
Retainer AISI304
Shield AISI304
Seal*2 Nitrile rubber
Lubricant*3 Heat-resistant grease

    *1 Available with ceramic balls(Si3N4
    *2 Available with fluorine rubber seal
    *3 Available with fluorine grease of chemical and heat resistance, food grade grease and other special greases.

 

●SSXCA type with aligning function and set screw

Standard Specifications
Aligning ring AISI440C
Inner and Outer Rings AISI440C
Balls*1 AISI440C
Retainer AISI304
Shield SUS304
Set screw AISI304 equivalent
Lubricant*2 Heat-resistant grease

*1 Available with ceramic balls(Si3N4
*2 Available with fluorine grease of chemical and heat resistance, food grade grease and other special greases.

 

Applications

Rollers for chemical film conveyor, clean room application, food machinery, glass substrate equipment, cleaning system, printing machine conveyor, etc.

Precautions

  1. Recommend fit to housing bore is H class of tolerance rang. Please consult with us in case of special use conditions.
  2. Axial load may impair the aligning function, therefore is not recommended.
  3. Please refer to the chart below for the recommended tightening torque. Adhesive bond is not recommended. It may damage the bearing.

●Recommended tightening torque

Set screw size Torque N・m
M3 0.7
M4 1.8
M5 3.0
M6 4.0